Warenkorb

Ihr Warenkorb ist leer

Ihr Warenkorb ist leer

3pcs AD828 Stereo Preamplifier Board Preamp Power Amplifier Board AMP Module DC5V-15V 12V

Kostenloser Versand ab 25.99€

8.39€

3 .99 3.99€

Auf Lager
  • AD828 Stereo Preamplifier Board Preamp Power Amplifier Board
  • Working voltage: DC 5V-15V
  • Small volume design, full patch process, input and output coupling capacitors using imported non-polar brand capacitors


Description:
AD828 Operational amplifier front amplifier, audio amplifier module, single power supply. Small volume design, full patch process, input and output coupling capacitors using imported non-polar brand capacitors, operational amplifiers using fever grade AD828 patches.
If you feel that the default magnification is not appropriate, you can change the magnification by yourself as follows:
How to adjust magnification:
R7 and R5 are the magnification setting resistors (the default delivery is about 5 times magnification, you can change the magnification according to your own needs, the resistance can be selected from 5k-47k, the greater the resistance, the higher the magnification, if you use plug-in resistors , You can remove the original chip resistor and solder the plug-in resistor on the pads reserved at both ends of the chip position)
Specification:
Working voltage: DC 5V-15V
Board size: 33x25mm/1.3"x0.98"
Note:
The board has no voltage regulation function. It is best to use a regulated power supply or battery-powered, otherwise there may be interference.
Package included:
3* AD828 Stereo Preamplifier Boards


Renrew Lekrof
Bewertet in Deutschland am 31. Januar 2025
Es handelt sich um einen Dual-Opamp vom Typ AD828 in invertierter Schaltung mit Verstärkung ca. -10. Eingangswiderstand sehr niedrig mit nur 2 kOhm. Könnte niederohmige Lasten (Kopfhörer) bis 50 mA treiben, aber leider sind die Elkos am Ausgang mit 10uF dafür zu klein dimensioniert. Wegen der Elkos ist außerdem die Versorgungsspannung auf 16V limitiert obwohl der AD828 30V könnte. Abzug wegen ungeschickter Schaltungsauslegung. Warum keine nichtinvertierende Auslegung mit höherer Eingangsimpedanz?
Produktempfehlungen