Ihr Warenkorb ist leer
Ihr Warenkorb ist leerMOLLE-System: Nach dem Zusammenklappen wird der ganze Tisch zu einem MOLLE-Panel. Dieses Panel kann MOLLE-Taschen, Werkzeuge, Feuerlöscher und alles, was Sie sich vorstellen können, halten, das in ein MOLLE-System passt
Pg1222
Bewertet in den USA am1. Januar 2025
Took a chance using this on my Bronco Raptor and it worked great. Had to take a Dremel tool with a cut off wheel to cut two slots for the lower standoff bolts with the kit.To be honest I didn’t have the highest expectations but it got decent reviews, had the two shelves and the moly slots on the back to mount my gear.The table is sturdy. It actually was a pretty quick and easy install. 30-45 min total. I didn’t want to do stand off mounts and was going to do something different at first but went ahead with the standoffs and it worked out better. There is a small slot between the tailgate and the table for plastic bags for trash etc. Also I can remove the table if I have to get to the wire behind it that Ford drops behind it for a future accessory.All in all highly recommend. I was not compensated at all for this review either.
Chris
Bewertet in Kanada am 5. August 2024
Easy to Install. Once I removed the plastic swing gate panel I discovered Jeep had marked the back with the spots to drill. No measuring required.After the holes were drilled and the panel reinstalled it was easy to mount the table with the provided hardware.
Greg Dondale
Bewertet in Kanada am 20. August 2024
This is a very nice unit, plenty sturdy and easy to install, only 4 holes to drill (13mm)But don't know what these are for ?
William
Bewertet in Kanada am 20. Januar 2024
Good quality. Easy to use.A bit heavy though.
Lucy Koch
Bewertet in den USA am17. Juni 2023
This was super easy to install. We have a JK and decided to modify the black strip that covers the wires. We used a multi-tool to cut off the three clips that correspond to the mounting points and then drilled holes large enough to go around the black spacers for the table and reinstalled the strip. You could probably do a passable job of that with a good utility knife in a pinch. We though about cord wrap to hide the wires but this was pretty easy and looks very finished.
Produktempfehlungen
