Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Farbe: Schwarz, Rot, Gelb, Blau.
Typ: 2-polig.
Platz: 2 54 mm. 25,4 cm.
Maße: 6 x 5 x 2,5 mm.
Jumper für den Einsatz auf Festplatten, Leiterplatten, Computer-Schnittstellenkarten, auch für die Verwendung mit Arduino, Raspberry PI Boards.
Lieferumfang: 200 x Pullover-Kappen in 4 Farben (rot, gelb, blau und schwarz)
P. R.. Fectionist
Bewertet in den USA am11. Februar 2024
The product is OK although the jumper plastic is rather brittle.Typical Amazon packaging was terrible. I also ordered two 625 sheet reams of 24# paper, being about 7.5#/625 sheets. Amazon shipping decided to place the little clear and hard plastic box with these jumpers in the same cardboard box WITH NO PACKING. Of course, the two 7.5 pound reams of paper shifting around in the oversized cardboard box totally smashed the jumper's plastic case, scattering them inside the cardboard box.Come on Amazon, think about how your packaging department is placing "compatible" and "non-compatible" items in the same box.
David Diamante
Bewertet in den USA am10. November 2024
Fits fine
Aaron
Bewertet in den USA am14. Januar 2020
Work well, nice fit, not too loose. Will buy again when i run out!
Justin Conner
Bewertet in den USA am3. August 2019
This is a maker's lifetime supply of jumpers. They install easily as well as cleanly. They also have a low profile that allows them to be installed on headers that will have another pcb sitting over them. In other words, the installed hight over pins is less than the hight of a female header. I'm using these for step selection on a Cnc Shield stepper motor driver. Also a cheap signal generator for waveform selection where they are also working as expected.
Customer
Bewertet in den USA am13. August 2019
A lot of items for not too high cost
Produktempfehlungen
