Ihr Warenkorb ist leer
Ihr Warenkorb ist leer 20 V Version kann durch Lötpads in 5 V/9 V/12 V/15 V umgewandelt werden, wie in den Fotos gezeigt.
Betreiben Sie ein elektronisches Projekt oder konvertieren Sie alte Hardware zur Verwendung von USB-C-Eingang.
Führt PD-Stromverhandlungen durch Unterstützt bis zu 5 A
Nicht alle USB-C-Netzteile können alle Spannungen unterstützen. Wenn die Stromversorgung die benötigte Spannung nicht unterstützt, wird die nächst niedrigste Spannung bereitgestellt. Das Modul führt nur die PD-Verhandlung aus und gibt den Ausgang über.
Um über 3 A zu verwenden, müssen Sie ein elektronisch gekennzeichnetes Typ-C-Kabel verwenden. Eine echte USB-PD-Stromquelle ist erforderlich, funktioniert nicht mit nur QC-Ladegeräten.
Richard Priddy
Bewertet in den USA am2. Januar 2025
These are so nice. I've started to take apart all of my electronics that use barrel plugs, replacing those with USB C. I think it's wonderful to not need dedicated adapters for all of my electronics. I've retrofitted battery chargers, network switches, my elliptical machine, a charger for wireless headphones, and more. As i have a bunch of outlets in my house that also have native USB C, it just makes for a super clean look.Love these things - though obviously be cognizant of what voltages you need.
2-bit reviewer
Bewertet in den USA am18. Januar 2025
I used these for an LED project at work. The beauty of these is that you can power a big set of LEDs with either a small phone charger or a good sized power bank. Add a buck circuit or a 5v UBEC near the LEDs, and you will never need to worry about wire length or voltage droop. Even better, this is a compact form factor, so you can hide the connection easilyThis is fixed voltage, so you will need to get the voltage that suits your needs (9v, 12v, 15v, 20v). So this is less suited for prototypes where you may want reusability and the ability to adjust the output. There are trigger boards with that capability in the same form factor, but they are a huge pain to adjust. It's better to get the larger trigger boards that have DIP switches.
Gaige B. Paulsen
Bewertet in den USA am10. Januar 2025
I am using this to power a 12V fan using a power brick that supports 12V and it works fine. The use case isn't particularly complicated, but for my purposes it works well.I was a little surprised to find the "2 pack" delivered with the two pieces connected to each other, but considering the size, it probably makes them less likely to get lost. They broke apart without difficulty and with no problems on the boards.
Gary O
Bewertet in den USA am25. Oktober 2024
Wanted to try to make a few 12v travel DC power supply dongle type things for my job. I made a rough enclosure and 3D printed it with some leads and this solution is so much more convenient than needing a DC wall-wart. I already had a usb-c charger that can do 12V output steps.
David
Bewertet in den USA am4. April 2024
This little device is just awesome. You can trick your portable cell phone style battery bank to output 12V at 5 amps max. Other voltages are possible (if your pack and trigger supports it). You need a true PD USB-C output and cable. Once you do, you can use this for everything and let the battery pack deal with the batteries. Works great and I wish I knew about them sooner.
Produktempfehlungen
