Habe die Module in deleyCON CAT7 Patchfeld eingebaut.Passt perfekt.

Verwende die Anschlüsse in einem Patchfeld unter dem Dach. Dort kommen alle im Haus befindlichen Dosen an. Nicht alle meine Receiver unterstützen Unicable, sodass ich ab und zu schonmal die klassischen Leitungen meines LNB in einem anderen Raum benötige. Das geht so kinderleicht hin und her zu tauschen.In den Dosen der Räume verwende ich allerdings feste Verdrahtung, weil hier ein rückseitiger F-Stecker zusätzlich Platz benötigt, und die klassischen Dosen schon da sind. Wer schon keystone Dosen sowieso hat, wird hiermit aber auch dort glücklich.

Wie bestellt, so erhalten. Techniker ist zufrieden.Danke

Ich habe alle in ein 24 Patchfeld (2-mal gekauft) eingebaut. Passen perfekt. Keine Defekte festgestellt. Hinten kommt das ankommende Kabel mit einem F-Stecker, vorne kann es dann verteilt werden. Vorne, hinten jeweils F-Stecker, leicht einzusetzen. Nicht gebrochen oder dergleichen.

très bon produit et livraison éclair

Die Lieferung war ok, weitere Erfahrungen mit "kwmobile 12x Keystone Modul F-Buchse" habe ich noch nicht.

AVOIDI purchased these to build an AV Patch Panel. They looked perfect for the job and well priced.First problem I hit - you cannot populate the panel and attach the coax cables later. It is impossible to screw on the F-Connector once they’re in the panel.Instead, you have to attach the cable before you click the keystone module into the panel. Even then, it’s very fiddley to screw on the F-Connector, as the design of the module obscures two sides of the nut. Meaning you have to tighten it in very short turns.Next problem – the connector holes that receive in inner copper wire of the coax, are blocked, or the tolerance is too tight. They will not receive the wire, no matter how much you push and work the cable, and ultimately the copper wire bends or collapses.You have to work the hole with a stronger piece of wire until it loosens, and can receive the coax. Then I hit the worst problem, and found that at least 3 out of 5 connectors had no continuity. I didn’t know this until the panel was wired and I started testing.I removed a few of the bad ones, and connected the cables with a double females by Labgear (from Screwfix) and they worked fine. Then replaced them with the Keystone Modules to again loose continuity. So no doubt these connectors are the root cause.That said; I’m not someone who immediately jumps for the bad feedback button. I always like to give suppliers the benefit of the doubt, and an opportunity to remediate. I therefore reached out and asked them for a solution, and confirmation that if I returned the components, they could be replaced with ones fit for purpose.Over several days I received the same automated reply;Dear Sir/Madam,We received your message and will contact you as soon as possible.Best regards,Team Customer support - KW-CommerceAfter expressing my disappointment at not receiving a meaningful response, I received the following;Hello,Thank you for your message.We passed this issue to our quality control for a verification and will get back to you as soon as we get a reply.Best regardsRonald Voigt[KW-Commerce]I replied, expressing my disappointment at the somewhat ambiguous statement, and received the following;Hello,We are sorry that you are not satisfied with your order.We passed this issue to our quality control for a verification.As it may take a while for the matter to be clarified, a refund can be made through Amazon.To request the refund, please go to "My Orders" in your Amazon account and select "Return an item from this order".Alternatively, you can also click on "Help" on any Amazon page and select the "Returns and refunds" section.We apologize for the inconvenience. Best regards[KW-Commerce]In summary, I feel they are aware of the poor standard, and have taken the approach of delay and avoidance, with a view to hoping the customer gives up, or makes the effort to return the item.It’s so disappointing that these poor standard of components are coming through Amazon. It’s becoming harder and harder to by a quality product.In my case, this is not just the inconvenience of returning the item. I’ve lost 1.5 days of effort, which will be extended by having to dismantle the panel, and re-install better quality components.Nevertheless, they will be returned, and no doubt shipped to another unsuspecting customer, who will waste an equal amount of time installing and troubleshooting these components, which are simply Not Fit For Purpose.

Ware technisch wie gewünscht. Lieferung fix. Sehr gut.