Ihr Warenkorb ist leer
Ihr Warenkorb ist leerFITS: Ender 5 (with Linear Rail System) Ender 5 Pro (with Linear Rail System) Ender 5 Plus (with Linear Rail System)
Tobias Gabriel
Bewertet in Deutschland am 24. Januar 2025
Sehr gute Verarbeitung und Funktion
Timothy A Stiel
Bewertet in den USA am27. Oktober 2024
Works good but no way to remove stuck filament without disassemble. Nozzle is in so tight I can't loosen.
dj1971
Bewertet in den USA am22. April 2024
Unlike others, i had no issues feeding filament into the extruder. The print quality is fantastic, and even at printing speeds over 200mm p/s, this does an excellent job.
SRW53
Bewertet in den USA am5. Oktober 2023
I had a recent meltdown of my extruder/hotend assembly on my Ender 5 Pro. I had not used it in a long while and all my steps and setting were from the last prints with same PTEG. My granddaughter wanted some special coasters for a party she was having, so a little pressure (she and wife). A quick look indicated some leakage in extruder/hotend area and since there was some smoke and burn marks, time to move on. Buddy of mine raved about MicroSwiss so I checked around and found that they had a complete bolt on assembly for linear rails (upgrade I installed early on) – done deal. Needed it quick so I had to go with Amazon. Arrived next day and the build quality, parts included, and installation instructions were “Outstanding”! I had the new assembly installed and up and running in a couple hours. Whew – crisis averted and coasters sent to a happy grandchild. The new parts inspired me to do a few more upgrades on the printer. This new Micro Swiss NG™ Direct Drive Extruder for Creality Ender 5/5 Pro / 5 Plus (Linear Rail Edition) saved the day.Easy recommendation.User picture User picture
D.J.
Bewertet in den USA am27. September 2023
Works beautifully, even after seeing all the reviews I decided to get this any ways since it seems to be one of the few decent well built extruder a in the market. Had a H2 v2s that did not print well at all and after months of troubleshooting and rebuilding the printer decided to chuck it and go with this. So far have about 72hrs on it with no issue
Thriznohgd
Bewertet in den USA am14. Oktober 2023
The stepper motor literally stops rotating in the middle of most prints with linear advanced enabled and always fails with it off. Lots of people online say to check the stepper motor adapter , turn off linear advanced, check for overheating but this is not the case. I will update my review if i can get it to reliably print. I may return this because lots of people online saying that the cable is defective or the stepper drivers cant handle StealthChop mode.Update: This is a known bug for my version of marlin 2 and i had to make custom configuration for my Sovol sv05 to manually update it. After marlin update problem is gone.
Produktempfehlungen
