Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Schutz gegen Überlast und Kurzschluss.Speziell für Multimeter entwickelt, gute Leistung und zuverlässig.
Hermann Glandorf
Bewertet in Deutschland am 23. Januar 2022
Und nun ist der Strommessbereich wieder perfekt geschützt.
Xavier Pinchart
Bewertet in Japan am 18. April 2021
Needed 400mA but this will do the job.Measured resistance 0.8 Ohm
Eisbär
Bewertet in Deutschland am 8. März 2019
Gute Verarbeitungsqualität und macht, wofür sie gebaut wurde.Das Preis/Leistungsverhältnis stimmt.
Cliente
Bewertet in Italien am 8. Februar 2019
costo elevato, consegna positiva
Keder
Bewertet in Deutschland am 7. Februar 2019
Ersatzteil
PC watchdog.
Bewertet in Kanada am 30. August 2019
To put in my multimeter. 1000 volts, 500 mA.6 weeks for delivery is incredible for simple fuses.
brian coppard
Bewertet in Großbritannien am 16. April 2018
Just what I wanted for fluke multimeter leads. Took a while to come but my fault for not checking delivery dates
DeusEx
Bewertet in den USA am4. April 2013
Even though the title said Amico, I recieved a SIBA brand. I've not researched if they own SIBA or that was just what the seller sent. In any case SIBA was what my Ideal 61-481 DMM had before, so I'm pleased to put one back in. This is a 6.3mm x 32mm which is a style used by many mid-range multimeters. It's a genuine HRC (High Rupture Capacity) ceramic fuse that unlike its cheaper glass brethren is less likely to shrapnel if it's hit with an extreme high energy jolt. Now this is not exactly what came out of my meter, my Ideal shipped with a 1A fast blow for the mA range. However I could only find this 500mA. If you decide to go this route, understand that it is also a fast blow so even a short spike over 500mA will toast it. Most of my mA readings are under a 100mA so that's fine with me. Another thing to pay attention to is voltage ratings. Barrel fuses can be rated from 60V on up. Double check and make sure your buying one rated for 1000V. Bottom line is, this fuse will serve my purposes without comprimising safety.Update: I beleive this is also the fuse that the Fluke 17B uses for its mA/uA over current protection. In any case I've been using my Ideal's mA range with its fresh new fuse. And at times I pushed the envelope. The current spike over 500mA for a few fractions of a second at a couple of differnt points through the test and survived. I must say that "forgiveness" is most welcome and I continue to sing praises about this replacement.
Produktempfehlungen
