Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Introduction
Raspberry Pi Pico 2 W is an official Raspberry Pi-designed, low-cost yet flexible development platform based on the RP2350, which is a wireless upgrade of the
Raspberry Pi Pico 2. It features all the characteristics of the Pico2 with the addition of a 2.4GHz wireless interface.
Features
RP2350 microcontroller chip designed by Raspberry Pi
Adopts unique dual-core and dual-architecture design, equipped with dual-core ARM Cortex-M33 processor and dual-core Hazard3 RISC-V core processor,
flexible clock running up to 150 MHz
Built-in 520KB of SRAM and 4MB of on-chip Flash
Supports Wi-Fi 4 wireless network and Bluetooth 5.2
Castellated module allows soldering directly to carrier boards
USB1.1 host and device support
Supports low-power sleep and hibernation modes
Drag-and-drop downloads can be made by USB recognition as mass storage
26 × multi-functional GPIO pins
2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 × controllable PWM channels
Temperature sensor
Accelerated floating-point libraries on-chip
12 × Programmable I/O (PIO) state machines for custom peripheral support
Development Resources
https://www.waveshare.com/wiki/Raspberry_Pi_Pico_2_W?Amazon
Package Content
Raspberry Pi Pico 2 W with pre-soldered header (color-coded) x1
1*3PIN yellow pin header x1
USB-A to micro USB cable ~1.2m x1
FAQ
Is there interference with Raspberry Pi Pico 2 W?
1.The pin that sets the input state must be initialized to pull up or down
2. Replace the USB cable and see if the USB cable is the one causing the problem
