Ihr Warenkorb ist leer
Ihr Warenkorb ist leerDiese Heizung hat eine hohe Qualität und verwendet geschlossene Edelstahlhülse, viel höhere Qualität als das übliche Heizrohr auf dem Markt.
mark liesicke
Bewertet in Großbritannien am 30. Dezember 2024
This cartridge is great. it gets my hotend to 270c in about 15 seconds, and overall seems well built. Now happily installed in my Ender 3 and will remain so after the E3NG Conversion!
Oliver Plavy
Bewertet in den USA am16. Oktober 2024
This heater cartridge heats up probably 3 times faster than the stock e3d v6 heater and it is a very affordable and a worthy upgrade for anyone who has an v6 hotend. Its very easy to install but make sure the printer's z-axis is not more than 250mm or the print head won't reach the full range of motion at maximum z-height.
Tim Alderman
Bewertet in den USA am14. Juni 2024
Great Upgrade or for a new build. Heats up faster than stock 40 watt heaters. Wires and Insulation are thick and sturdy. Works great over 200 prints so far. Installed on Voron 2.4 Canbus E3D V6 Hotend. I will be purchasing more of these.
Jaraxle
Bewertet in den USA am20. April 2024
I've used this heater cartridge in my QIDI i-mates (modded) for a few years, and now for 2 years in a ratrig vcrore-400. I print in high temperature nylons (around 300c) and this 60watt heater has never missed a beat. I always wait to leave a review, to insure the product actually lasts. When you change (or build) the heater in your hotend you need to run a PID process to tune your control board to the response of the assembly. This is based on the metal, airflow, and heater capability. I give this product FIVE STARS...
Jacob.
Bewertet in den USA am17. Mai 2022
The product does get really hot and it heats faster than stock. Only downside is the wires are to short to reach the mainboard on my ender 3. But its a simple fix, just simply solder them to the red wires for the stock heater and it works perfectly. I've been constantly printing nylon at 290~300c with no issues.Pros-It's really hot-install was easy (soldering may be required)-Heats way faster than stock.-Fit's ender 3Cons- It burned my hand
Produktempfehlungen
