Ihr Warenkorb ist leer
Ihr Warenkorb ist leerInternational products have separate terms, are sold from abroad and may differ from local products, including fit, age ratings, and language of product, labeling or instructions.
Martijn Franke
Bewertet in Italien am 28. Januar 2025
I couldn't get it to work with my Arduino and an external 5V power supply. Tried it with my lab power supply. I discovered the relays don't get triggered at 5.0V. But at about 5.6V they do, but I can't turn up my 5V supply that far. Then you have to put jumpers on the high or the low trigger pins, but those are not supplied. Useless rubbish.
Riccardo
Bewertet in Italien am 3. Oktober 2024
Tutto ok
SN Ciedil
Bewertet in Frankreich am 23. Mai 2024
La carte fonctionne en 12v et non en 5v comme indiqué, donc inutilisable avec notre carte de commande.
Client d'
Bewertet in Frankreich am 19. November 2024
La commande ne fonctionne pas en 5V. J'ai dû pousser à 9V pour que cela déclenche les relais.
Thomas Dove
Bewertet in Großbritannien am 12. August 2024
No instructions of any kind. Found what others had said to work out jumpers - BUT it does not work. It does not function with Arduino, despite what the description says. When the jumper for S1 or S2 is set COM to LOW, there is ~4V on the input, and the Arduino cannot sink or source the current to overcome this voltage and bring it down to 0. I tried shorting the S1 input to ground - which should turn the relay on, but it does not. The LED for S1 flashes briefly brightly then goes dim - looks like a fault unit
Produktempfehlungen