Ihr Warenkorb ist leer
Ihr Warenkorb ist leerJR
Bewertet in Deutschland am 8. April 2024
Wollte schon zurücksenden, da ich aufgrund fehlender Beschreibung nicht in der Lage war das Produkt richtig zu nutzen. Habe nach genauerer Recherche dann doch noch eine Beschreibung für dieses eigentlich ansprechende Produkt gefunden, und bin nun glücklich damit. Das Bild zeigt die Anschlüsse und die Ah-Anzeige nach Entladestop im 'Fun2 mode'.Mit Anleitung hätte ich 5 Sterne vergeben. Ohne gäbe es nur 2 oder 3. Nun kann ich 4 vergeben.Die im Netz gefundene Beschreibung (etwas modifiziert):Electronic load to test and revive rechargable batteriesInstruction manual for Constant Current Electronic Load 9.99A 60W 30VRound socket - work power supply, attach to any 12V source (at least 0.3A).Green socket with screws - to battery.Red micro button - Start/Stop.Rotating hadle also is a push-button.Two green LEDs between digital areas - selected part of the number you are changing (before or after digital point). To switch between them - press rotating handle. To change the selected number part - rotate the handle.To enter to settings menu - power up with Start/Stop pressed (and keep it pressed until you see settings).To select a setting value - rotate handle,to go to next setting - press Start/Stop.First setting - mode: Fun1 electronic load,or : Fun2 battery discharge (you can select min voltage to stop discharging).this might be the mode after which you pretty much were searching for.Second setting - buzzer on/off (bEon/bEoF)If you are not in settings, you can select discharge current,and, for Fun2 - voltage to stop discharging.While discharging, top digits switch continously between current voltage, Ah, Wh.Bottom digits shows - current.If the device had switched off at min voltage, you can see last values when you switch it on again.Start/Stop discharging - press Start/stop button.Current you can change during discharging.Min voltage has to be entered before discharging.They said that to clear values you have to press Start/Stop twice, but in my case I have to enter and exit settings for that.Error codesErr1 - too high battery voltageErr2 - too low battery voltage (or no battery connected or connected in wrong polarity)Err3 - battery resistance too high (cannot keep the current)Err4 - circuit failure (what’s that?)Err6 - work voltage power supply is not enough (need at least 0.5A)otP - overheating protectionErt - temperature sensor error (or temperature is too low)ouP - ultra-high voltage electronic load mode (what’s that?)oPP - under ultra-high power electronic load mode instantly (what’s that?)
Produktempfehlungen