Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Eine Druckkammer ist alles gut und gut, aber wenn Sie den Platz im Inneren maximieren, werden Sie eine raue Zeit haben, Würfel-Sets in einem vernünftigen Tempo zu machen.
Dies ist ein Regalsystem, das entworfen wurde, um kleine Formen in einem Harbor Güterdrucktopf während des Harzgussprozesses zu halten.
Der Ständer ist aus Birkensperrholz lasergeschnitten und wird mit Holzteilen geliefert. Der Ständer ist sehr einfach zu montieren, ohne Klebstoff oder Werkzeuge erforderlich. Die Verriegelungslaschen ermöglichen es Ihnen, jedes der Regale vom Ständer zu nehmen, um Formen unterschiedlicher Größen unterzubringen.
Größe:
19,1 cm hoch, 22,9 cm im Durchmesser (montiert).
Customer
Bewertet in den USA am2. April 2025
Great concept design but the supports being the middle limit how many molds you can put on it at once. If you have a leak, resin will stick to the wood and you won't able to get it off, leaving you with an uneven surface. There are much better pressure pot inserts out there.
P. A. Fipps
Bewertet in den USA am29. Oktober 2024
When assembled it becomes obvious that only small molds will fit. The way the pieces fit together, even the top shelf can not be used for larger flat molds. I ended up not using this, as too few of my molds would fit.
S. Loges
Bewertet in den USA am17. März 2023
Parts were laser cut fit and form were exceptionably good. fits i my pressure pot well.Recommend
Customer
Bewertet in den USA am9. Dezember 2022
I make handmade dice with resin and this was perfect to put in my pressure pot and make the most of the space. A little flimsy feeling and resin sticks to it pretty badly, but i still love it!!
-That- guy
Bewertet in den USA am26. März 2022
Just finished assembling this and quite pleased with the final product; however, it was a little tough to assemble as the tolerances were just a little bit too tight. I ended up having to use a screw driver handle as a sort of rubber mallet to get the first two pieces all the way together, and again to get the bottom plate on.I then used the torx head as it has a mostly flat end to push the circular locking bits in place, as they would not slide into their slots without the additional force.Good product, just a little hard to assemble.*Edit: I should also add that this fits perfectly well in my Vevor pot available on amazon which I converted for use with resin, so it's not just for the ones from Harbor Freight =)
Produktempfehlungen
22.49€
11 .99 € 11.99€
39.99€
16 .99 € 16.99€