Ihr Warenkorb ist leer
Ihr Warenkorb ist leer
Description:
This is an upgraded version of the Raspberry Pi GPIO expansion board, which can connect more devices to the same GPIO pin.
Features:
Easy to assemble
Pin silk screen marking
GPIO function definition
BCM Naming system
Package Includes:
1 x Easy Multiplexing Board
4 x Copper stick
4 x Screws
4 x Nuts
Wiki:
https://wiki.52pi.com/index.php/Easy_Multiplexing_Board_SKU:_EP-0123
Aramis
Bewertet in Italien am 7. Januar 2024
Espansione funzionale ed economica
M
Bewertet in Deutschland am 18. Dezember 2023
Zubehör für den Pi. Verarbeitung gut.
Leobo
Bewertet in Deutschland am 29. Januar 2022
Qualität ist sehr gut. GPIO Pins sind sehr gut, bei manchen Hersteller sind die pins zu dünn. Kontakte sind sauber. Top.
Iakovos Bitsakis
Bewertet in Deutschland am 25. Juli 2022
Every item was like it should be!! No bad surprises ....Arrived on scheduled time, nice seller!!!!
Eduard Kurz
Bewertet in Deutschland am 24. März 2022
gut
Rotkreuz 51 / 01
Bewertet in Deutschland am 23. Februar 2022
Alles ok
Regimantas
Bewertet in Deutschland am 29. Januar 2021
ok
pufferfish
Bewertet in Großbritannien am 2. Januar 2021
Yeah a bit of an oversight, well, no, it's not an oversight I guess, but a design feature of these header pins and shields. If you don't "stack them" (some actually do have long through pins...seen it on arduino) then you are basically one shield and done. Sorry...we call them "hats" on the pi don't we.Anyway point is, this allows multiple "hats"Well.Sort of.I can't see how you get more than one hat on, then the rest you're back at pins or an extension.It's a means to a very specific end I guess.Most of the stuff I do ends up using a breadboard so while this is fun, I could get by with just a 2 way breakout. I can't see why four in this configuration is any help - Nonetheless, the more the merrier.Be careful not to reuse pins. Not that it will necessarily break anything, it just...confuses...matters...unless you know what you're doing, stick to 1 pin, 1 in/output.
Mario
Bewertet in Deutschland am 14. August 2021
Funktioniert einwandfrei, ist sehr einfach zu montieren.Es kann nur sein dass manche Gehäuse nicht hoch genug sind und damit geht der Deckel nicht zu.Aber sonst anstecken und loslegen.
A Reviewer
Bewertet in Großbritannien am 30. November 2020
What a fab idea this is!Brilliant for prototyping new projects where you might have lots of stuff to attach, reconfigure, etc. and this makes it so much easier to have lots of bits and pieces attached to your Raspberry Pi at the same time.All screen printing is perfect on mine so everything's clearly marked. It comes with the necessary mounting hardware to fit it directly onto the Pi's screw holes.
Annelise O
Bewertet in Großbritannien am 20. November 2020
Great breakout with 4 GIPO available to use. The screen print was slightly off on mine but did not affect the performance.
Daddo
Bewertet in Großbritannien am 14. November 2020
Great for prototyping on the Pi 4. This breaks out all of the GPIO pins for easy access. Can be used with a ribbon extension if your case does not allow direct mounting.
Produktempfehlungen
16.45€
7 .99 € 7.99€
31.93€
15 .99 € 15.99€