Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktbeschreibung des Herstellers
Hugh
Bewertet in Großbritannien am 1. September 2024
Got the job done without using pipework fittings
Jon Walton
Bewertet in Großbritannien am 15. Juli 2021
Was very disappointed with this. It rippled the pipe at every use. Will stick with my 15/22 pipe bender using the spoons.
Hust13r
Bewertet in Spanien am 1. August 2021
Basicamente, uno de los mejores cortatubos que se puede comprar con dinero.
Gary
Bewertet in Großbritannien am 13. Juli 2020
It arrived on Friday, pulled a 180 bend and it rippled the entire length of bend.Returned the brand new RIDGID £100 15mm 180 degree pipe bender, replaced with an identical model.It identically ripples too.Worst rippling I've ever seen on a pipe bender in 30+ years of using pipe benders.Types K, L, M (mostly American) pipe wall thicknessK = 1.24mmL = 1mmM = 0.7Types X, Y, Z wall thickness (Type X is the most common type used in UK)X = 0.7mmY = 1mmZ = 0.5mmSo our type X is .54 to .3mm thinner than types K & L.Additionally types K & L are 220 N/mm2 whereas type X is 250 N/mm2.Meaning, type X is semi hard drawn copper pipe, whereas types K & L are soft copper tube.Types K, L are generally used in refrigeration, air con, heat pumps.Types X & Y are used in water, heating, gas, within the home/light commercial.So unless you're in the minority who works solely in refrigerants/heat pumps then this tube bender is not for you.I've included some images, of the rippling by the RIDGID 'tube bender', and shown a comparrison to my old trusty hilmor 'pipe bender' with no ripples, how it should.
Basilio
Bewertet in Spanien am 13. August 2020
👍
Produktempfehlungen
309.00€
99 .00 € 99.00€