Ihr Warenkorb ist leer
Ihr Warenkorb ist leer
Overview
Arduino Uno is sometimes frustrating when your project requires a lot of sensors or Leds and your jumper wires are in a mess. The purpose of creating the Grove ? Base Shield is to help you getting rid of bread board and jump wires. With the rich grove connectors on the base board, you can add all the grove modules to the Arduino Uno conveniently!
Features
There are intotal 16 grove connectors on the Base Shield, here we use a table to show the details.
Analog: A0/A1/A2/A3: 4
Digital: D2/D3D4/D5/D6/D7/D8: 7
UART: UART: 1
I2C: I2C: 4
Apart from the rich grove connectors, on the board you can also see an RST button, a green LED to indicating power status, ICSP pin, a toggle switch and four row of pinouts. There is no need to explain the RST button and LED, but you really need to know below two features that is very important.
1.Power Compatible:
Every Grove connector has four wires, one of which is the VCC. However, not every micro-controller main board needs a supply voltage of 5V, some need 3.3V. That's why we add a power toggle switch to Base Shield v2 so that you can select the suitable voltage of the micro-controller main board you are using via this switch.
2.Board Compatible:
The pinout of Base Shield V2 is the same as Arduino Uno R3, however Arduino Uno is not the board one that the Base Shield V2 is compatible with, here we listed the boards that we have confirmed that can be used with Base Shield V2.
Arduino Uno
Seeeduino V4.2
Arduino Mega / Seeeduino Mega
Seeduino LoraWan
Arduino Leonardo / Seeeduino Lite
Arduino 101
Arduino Due
Intel Edison
Linkit One
Technical Details
Dimensions: 69mm x 53mm x 23mm
Weight: G.W 25g
Battery: Exclude
Part list
Base Shield V2 x1