Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Zwei reihiger, recht winkliger Montage winkel, Stift Leiste, elektrische Komponente, ist einfach zu installieren.
Diese Stift Leiste ist ein guter Buchsen stecker für die Leiterplatte und die integrierte Schaltung und wird häufig in Computern und Steckplatinen verwendet.
P. Meyer
Bewertet in den USA am20. August 2023
I did not notice the pitch, I wanted 2.5mm. These are cute but I have no use for them. Into the stockpile they go…
Steven A. Hancock II
Bewertet in den USA am21. Oktober 2020
If you need to populate the JTAG header on Atmel Xplained or similar boards, these are what you're looking for. They're tiny and really hard to solder by hand, but I didn't expect anything this small to be easy. I suggest using a very fine tip and working under magnification, or use some paste (apply sparingly) and a heat gun if you have them and know how to use them.
Arthur
Bewertet in den USA am26. Januar 2018
A++
Customer
Bewertet in den USA am1. März 2018
Exactly what I needed and they work great! In case you don't know, the pitch is measured from the center of one pin to the next pin. Also if you are in doubt of what size you need, it's likely that if your measurement is close to one of the more common sizes then that is probably what you should order. Common pitches for header pins are 2.54 millimeters (0.1 in) or multiples of 2 or divisions of 2 ex: 1.27 millimetres (0.05 in) and 5.08 millimetres (0.2 in) are also very common.These are the 1.27mm and I measured about 1.3mm with a set of calipers.
Ed Kap
Bewertet in den USA am8. September 2017
The item received was exactly as described. Very fast shipping. These are the smaller 0,05" pitch while most of these are in 0.1" pitch. The description was accurate, though. Thanks.
Produktempfehlungen
