Ihr Warenkorb ist leer
Ihr Warenkorb ist leer
x2pcs HC06 Bluetooth Serial pass-through Module Wireless Serial Communication from Machine Wireless HC06 for arduino Bluetooth Module
DESCRIPTION:
1,Core module uses HC06, leads from the module interface includes VCC, GND, TXD, RXD, reserve LED status output pin, the microcontroller can be judged by the foot state Bluetooth has connected KEY pin slave invalid.
2, led indicate Bluetooth connection status, flashing Bluetooth connectivity, lit the Bluetooth connection and open a port Backplane
3, 3.3V LDO input voltage 3.6 ~ 6V, current is about 30mA unpaired, paired about 10mA, the input voltage to prohibit more than 7V!
4, the interface level 3.3V, can be directly connected the various SCM (51, AVR, PIC, ARM, MSP430, etc.), the 5V MCU also can be connected directly, without MAX232 can not go through the MAX232!
5, open to the effective distance of 10 meters, over 10 meters is also possible, but not of this the quality of the connection of the distance do to ensure
6, after the pair when full-duplex serial port to use, do not need to know anything about the Bluetooth protocol, but only supports 8 data bits, 1 stop bit, no parity communication format, which is the most commonly used communication format does not support other formats .
7, support for Bluetooth connection is not established by the AT command set the baud rate, name, passkey, set parameters are saved after. Bluetooth connection is automatically switched to the pass-through mode
8, the link from the machine, computer, Bluetooth with Bluetooth function from the function with a variety of hosts, the majority with a Bluetooth-enabled cell phone, PDA, PSP and other intelligent terminal pairing from not pairing between the machine.
PACKET CONTAINS:
2pcs x HC06 Bluetooth Serial Transceiver Module
AR
Bewertet in Spanien am 9. Januar 2025
todo perfecto.un saludo gracias
Alberto
Bewertet in Italien am 11. November 2024
Sono semplici e facili da usare con ARDUINO per chi ha esperienza con ARDUINO.
R.S
Bewertet in Deutschland am 24. August 2023
Ausgepackt eingesteckt und blinkt nur mehr kann man nicht damit machen, ich habe drei TTL, einen FTDI und Adruino uno ausprobiert und man bekommt keinen einzigen AT befehl oder Parameter geändert leider Elektro Müll.
José Antonio Vazquez
Bewertet in Spanien am 6. Januar 2022
Perfecto, cumple su cometido
Marcus
Bewertet in Schweden am 29. August 2022
Good
Giancarlo
Bewertet in Italien am 14. März 2019
Prodotto utilissimo e facile da usare e configurare per far comunicare dispositivi diversi. Io l'ho usato con per controllare una scheda Arduino con il mio Smartphone.
Produktempfehlungen
7.55€
2 .99 € 2.99€