Ihr Warenkorb ist leer
Ihr Warenkorb ist leer 1.27inch OLED Display Module
Embedded SSD1351 Driver Chip, SPI Communication
Comes with examples for Raspberry Pi, Arduino, STM32, etc.
Specifications
Operating voltage: 3.3V/5V (Please ensure that the power supply voltage and logic voltage are consistent, otherwise it will not work properly)
Support interface: 4-wire SPI, 3-wire SPI
Controller: SSD1351
Resolution: 128(H)RGB x 96(V)
Dimension: 25.708 × 19.28mm
Pixel size: 0.047 × 0.185mm
Display color: 262K color
Control Interface
RES---Reset, low active
DC---Data/Command selection (high for data, low for command)
CS---Chip selection, low active
CLK---Clock input
DIN---Data input
GND---Ground
VCC---Power (3.3V / 5V input)
OLED and its controller
The built-in driver used by this OLED is SSD1351, which is a 128RGB * 128 Dot Matrix OLED/PLED controller with a 128*128*18bit SRAM as a display
buffer area, which supports two color depths of 262k and 65k. And supports 8bit 8080 parallel, 8bit 6800 parallel, 3wire-SPI and 4wire-SPI and other
communication methods.
This module selects 4wire-SPI and 3wire-SPI as the communication method, which reduces the area of the module and saves the IO resources of the
controller.
Development Resources
https://www.waveshare.com/wiki/1.27inch_RGB_OLED_Module?Amazon
Package Content
1.27inch RGB OLED Module x1
GH1.25 7PIN cable x1
Note
Techinical Support is provided, please contact us if you have any problem .