Ihr Warenkorb ist leer
Ihr Warenkorb ist leerEdward Frenette
Bewertet in den USA am24. März 2025
Arduino works well, I almost sent it back initially because the other reviews said the boards had the new bootloader installed, but mine did not.I needed to set the programmer to old bootloader in the arduino ide in order to program the boards
Waldemar B.
Bewertet in Deutschland am 19. Februar 2025
Product okay, but pinout drawing totally wrong!!!
Jose R.
Bewertet in den USA am10. März 2025
I can’t leave a 1-star cause these may work for some people, and I can’t give 5-star cause these don’t work for me, cannot send a sketch to them. Something with clone boards that gotta give connection troubles. I think I’m gonna just stick with Arduino brand boards. So far all my Arduino brand boards I have don’t give me problems, knock on wood.
Rosenie
Bewertet in den USA am11. April 2025
All work great, no complaints on my end.
Ds
Bewertet in den USA am24. November 2024
The boards worked well, plug and play for programming with Arduino IDE. Only issue I had was the ICSP header pins were backwards from the genuine boards. They are correct according to the images in the Amazon product page, but if you search for the Nano pinout on the internet it will give you the incorrect header pins for this product. Be aware in order to not mix up power/GND/signal pins based on an incorrect diagram.
Preston
Bewertet in den USA am20. Dezember 2024
This is a good alternative to an Arduino NANO. I've soldered the pins on one of these boards already and used it in one of my projects. It works exactly as I expected it to, even with the Arduino IDE. I wish the included USB cable were a bit longer, though, so I don't have to bring my entire project up to my computer USB port.Surprisingly, other USB-C charger cables I've had didn't allow these boards to be detected/programmed so I HAD to use the included short cable. I suspect this is normal with Arduino NANO boards so this probably isn't an issue. The included cable works fine, anyways.I've included some pictures. I used clay to hold the electronics onto my board while I solder the underside. Board was tested in a fairly complex project and all the digital/analog pins worked fine.
Produktempfehlungen